opkmemphis.blogg.se

Komplete kontrol m32
Komplete kontrol m32








You can use the procedure of (1) but "pressing" buttons in the "Faders" column instead of touching M32 knobs (remember you have 4 banks, so 32 faders in total). Focus plug-in in question, you should see current mapping. Open AZ Controller UI, switch to ACT Tab.

komplete kontrol m32

If not, parameters you wanted are not "learnable" (see method (3)) Modify some plug-in parameters in sequence (using mouse), then turn M32 knobs (in ACT mode) in the same sequence. You press ACT Learn button "A L" (if you are learning FX it is right there, if you are learning PC Module use one on ACT top bar module). That is why I write partially.īy default when there is no mapping (after deleting all XMLs) everything is mapped to "ACT knobs". With this preset M32 controls so called "ACT faders" only, delivered mappings are primary for 8+8+8 Faders/Knobs/Buttons. It can be some of them was partially usable.

komplete kontrol m32 komplete kontrol m32

In pre-installed XMLs there was "some" mappings.










Komplete kontrol m32